Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Dallas Owner’s Guide

Ghost Controls keypad and intercom repair in Dallas typically runs $145 to $320 installed, depending on whether we’re replacing the keypad face, the intercom board, or the full weather-sealed unit. Most jobs are done in one visit, and we carry Ghost Controls-compatible keypads and intercom modules on the truck. The usual story we hear: the keypad stopped responding after a hard rain, or the intercom audio cut out on one side, or the whole unit went dark after a power surge. In Dallas, the failure pattern is predictable: heat-driven board fatigue in summer, moisture intrusion after spring storms, and UV-brittle keypad membranes year-round.

Call (940) 531-9746

Key Takeaways

• Installed Ghost Controls keypad & intercom repair in Dallas: $145 – $320, written price before work starts
• We stock Ghost Controls-compatible keypads, intercom boards, and mounting hardware on the truck
• Most replacements take 45 to 90 minutes on site
• Our work carries a written guarantee for a full year, parts and labor
• Carver Gate Repair Dallas is an independent service provider, not affiliated with Ghost Controls

Which Ghost Controls Models This Applies To

This repair scope covers Ghost Controls keypads and intercom modules paired with the brand’s swing and slide gate operators: the AXP1, AXS1, SXP1, SXS1, and the DTP1/DTS1 series for heavier gates. Ghost Controls sells keypads and intercoms under both the standard residential line and the pro-grade “Pro” line, and the two are not interchangeable. The residential keypads use a flat four-wire connection into the operator board; the Pro intercom uses a separate data bus and a different mounting footprint. If you’ve got a Pro-series intercom, a residential part will not talk to your board even if the plug fits.

How to identify what you need: open the battery compartment or the rear cover and look for the part number, which starts with an “AXP” or “SXP” prefix on residential keypads, or “PRO” on the intercom side. We genuinely prefer OEM Ghost Controls parts on intercoms because the aftermarket boards we’ve tested don’t handle the Dallas heat cycle as well, especially the audio amplifier section. On keypads, a quality aftermarket replacement is often just as good as OEM, and it saves the homeowner $40 to $60 on the part. We’ll give you the choice, with a straight recommendation based on your exact model.

Signs Your Ghost Controls Keypad & Intercom Is Failing

• Keypad is dead with no backlight and no beep. This is almost always board failure from a power surge or moisture intrusion. The keypad’s low-voltage feed is the first thing to go. We confirm by testing voltage at the operator board, not at the keypad face.
• Some buttons work, others don’t. The membrane under the keys is cracked or the carbon contacts have worn unevenly. On Dallas homes near the lake, like Lakewood or White Rock, we see this more often because humidity accelerates membrane degradation. A new keypad face resolves it.
• Keypad works but the gate won’t open. The keypad is sending the signal, but the operator board isn’t receiving it. The problem may be in the wire run, the connector, or the operator board itself. We test the circuit before ordering any part, so you don’t buy a keypad you don’t need.
• Intercom audio is crackling, one-sided, or silent. On Ghost Controls intercoms, the speaker and mic pair share a board with the audio amp. Heat in an enclosed keypad housing, which bakes in a Dallas afternoon, kills that amp section first. A board swap fixes it. A speaker-only replacement usually does not.
• Unit works intermittently, especially after rain or heavy dew. Water is getting into the housing around the gasket or through the wire entry. Dallas gets enough hard, fast rain that a failed gasket can take out a unit in one season. We reseal the entry point and replace the damaged board or keypad.

Replacement Cost & What’s Included

Here’s what we quote on Ghost Controls keypad and intercom jobs in Dallas:

• Keypad replacement (residential line), installed: $145 – $210
• Keypad replacement (Pro line), installed: $185 – $260
• Intercom board replacement, installed: $210 – $320
• Full intercom head replacement with new housing and gasket: $280 – $380
• Diagnostic fee (waived if we do the repair): $75

The range depends on which Ghost Controls series you have, whether we’re using OEM or aftermarket on the keypad side, and what the wiring looks like once we open the housing. You get a written price before any work starts, and that price doesn’t move unless we find something you haven’t approved. Every Ghost Controls keypad and intercom repair we do in Dallas carries our written one-year guarantee on parts and labor. If the same part fails inside that year, we come back and fix it at no charge. That includes the second-visit callout.

DIY or Call Us?

These are low-voltage systems. The danger isn’t a shock. The danger is misdiagnosis and buying a part that doesn’t fix the problem. A homeowner can absolutely check two things: clean the keypad face with a dry cloth, and confirm the operator itself has power by pressing the gate’s manual open button. If the operator works but the keypad doesn’t, you know the issue is in the keypad or its wire run, not the motor. Beyond that, the safe zone ends. Ghost Controls boards and connectors aren’t forgiving, and a miswired keypad can send the wrong signal or short the operator board. That turns a $160 repair into a $600 one. If you’re not certain which wire lands where, call (940) 531-9746. We’ll tell you over the phone whether it sounds like a keypad, a wire, or a board issue, and you’ll get an honest read before we ever run a truck.

Lonnie Burke, who runs Carver Gate Repair Dallas, grew up in the San Fernando Valley and came up through the welding and industrial maintenance program at Los Angeles Trade-Technical College. He’s been diagnosing gate opener failures and board problems across Dallas for the better part of two decades, including residential and commercial work along the Kessler Park corridor. If I can’t tell you exactly what’s wrong before I touch it, I haven’t looked closely enough. We carry Ghost Controls keypad and intercom parts on the truck when we roll, so most Dallas repairs are done on the first visit.

FAQs